Cal Spas Portable Spas Benutzerhandbuch

Page 28 

2009 Portable Spa Owner’s Manual

 

LTR20091001, Rev. A

This plan and its chemical dosages are intended for spas equipped with the optional Cal Clarity Automatic Bromine 
Generator. The chemical references are designed for Cal Spas chemicals only. Note: Following these instructions 
is very important to ensure proper operation of your Cal Clarity Automatic Bromine Generator.

Clean  surface  of  spa  with  Cal  Spas  “Multi-

1. 

Purpose Cleaner”.

Apply  a  protective  coat  of  Cal  Spas  “Fast 

2. 

Sheen” to the acrylic surface.

Fill spa to proper water level with normal tap 

3. 

water. (Do not use soft water.)

Use Bromine Test Strip and balance the spa 

4. 

water:

Adjust total alkalinity (acceptable range is 

• 

80-120 ppm)

Then adjust pH if necessary (between 7.2 

• 

to 7.8)

Pour in 16 oz. of Cal Spas “Metal Protector” 

5. 

to center of spa.

Test for TDS (total dissolved solids, also known as conductivity) .

6. 

The ideal range is 50 to 300 ppm. 

• 

TDS / conductivity must be less than 500 to start with.

• 

Phosphate level should be below 200 ppb. Remove phosphates if necessary.

7. 

Determine the gallons capacity of the spa. Be accurate as this determines the amount of TRU BLU that will be 

8. 

added. Consult the Pre-Delivery Guide for spa gallons.

Power up the spa and make sure all the spa’s pumps are set to high speed. Turn the dial on the face of the Cal 

9. 

Clarity Bromine Generator to “OFF”.

Sprinkle evenly over the surface of the spa, one 2 lb bottle of TRU BLU sodium bromide per 100 US gallons 

10. 

(370 liters) of water. DO NOT ADD TOO MUCH!

Note: Each bottle of TRU BLU will raise TDS / conductivity amount approximately 500 ppm in a 500 gallon spa.

Allow spa to run for 15 minutes so the TRU BLU can dissolve completely before proceeding to the next step.

11. 

Remove dirty filter from the spa and rinse off.

4. 

Place your extra clean filter cartridge back into the 

5. 

spa.

Vacuum debris from the bottom of your spa with the 

6. 

“Spa Vacuum”.

Test spa water using Chlorine Test Strips.

1. 

Based on the Test Strip reading: 

2. 

Adjust total alkalinity, then the pH if needed. 

• 

Add  1  tablespoon  of  Chlorine  Granules  (if 

• 

needed).

Add 2 oz of Oxidizer Shock to spa. Run Spa for 15 

3. 

minutes with cover off. 

Replace cover.

4.