Hunter Fan 41457-01 Benutzerhandbuch
31
41457-01 7/2000
®
OPERATING YOUR HUNTER FAN
WITH A REMOTE
WITH A REMOTE
Once receiver is installed and
power is turned back on, DO
NOT pull the fan or light chains
while power is connected.
power is turned back on, DO
NOT pull the fan or light chains
while power is connected.
WARNING
Refer to steps 1, 3, and 4 in the OP-
ERATING YOUR HUNTER FAN
WITHOUT A REMOTE. Use the
following steps to operate your
remote.
WITHOUT A REMOTE. Use the
following steps to operate your
remote.
1. Turn ON the wall switch. The light
will turn ON at maximum bright-
ness.
ness.
2. Light Operation:
Press and quickly release the light
button on the hand held remote
to turn the light OFF or ON.
button on the hand held remote
to turn the light OFF or ON.
Press and hold the light button for
more than 0.7 second to dim or
more than 0.7 second to dim or
LOW MED HIGH
Display
Light Button
Fan Button
brighten the light. Release the
light button when the desired
light level is reached. The light
dimmer range is 20% to 100%.
The Light key has auto resume,
so the brightness will stay the
same as the last time it was turned
OFF. Refer to Figure 12c.
light button when the desired
light level is reached. The light
dimmer range is 20% to 100%.
The Light key has auto resume,
so the brightness will stay the
same as the last time it was turned
OFF. Refer to Figure 12c.
3. Fan Operation:
Press the fan button to turn ON
the ceiling fan at High speed.
Press again to change the speed
to Medium, then again to Low,
and then again to turn the fan
OFF. Refer to Figure 12c.
the ceiling fan at High speed.
Press again to change the speed
to Medium, then again to Low,
and then again to turn the fan
OFF. Refer to Figure 12c.
Note: If fan is not reaching de-
sired speed or light does not
come on, refer to the TROUBLE-
SHOOTING section.
sired speed or light does not
come on, refer to the TROUBLE-
SHOOTING section.
Figure 12c - Remote Transmitter