Ariens Deluxe 24 Benutzerhandbuch

GB - 26

Wipe each fitting clean before 

and after lubrication. Do not wipe gearcase 
filler plug; wiping the gearcase filler plug may 
remove thread sealant and cause leaks.

DO NOT allow grease or oil to 

get on friction disc, friction plate or belts.

Apply Ariens Hi-Temp Grease or 

equivalent to the lubrication fittings. See 
SERVICE PARTS on page 37.
Sno-Thro should be lubricated (Figure 26) at 
beginning of season or every 25 operating 
hours.

Damage to auger/impeller 

housing will result if blade wears down too 
far.

Scraper blade is adjustable to compensate 
for wear.
To adjust scraper blade:

1. Tip unit back onto handlebar, support 

housing and loosen nuts retaining blade.

2. Adjust skid shoes to fully raised position 

(housing closest to ground). 

3. Reposition scraper blade flush with skid 

shoes and tighten lock nuts. 

Skid Shoes should be adjusted as conditions 
require (Figure 27).

1. Position unit on a hard, flat, smooth level 

surface. 

2. Adjust skid shoes by inserting a spacer 

of desired thickness under center of 
scraper blade, loosen skid shoe 
hardware, slide skid shoes to flat 
surface. Allow 1/8 in. (3 mm) between 
scraper blade and hard smooth 
surfaces. Allow 1-1/4 in. (30 mm) 
between scraper blade and uneven or 
gravel surfaces. Retighten hardware.

Figure 26

Oil 

Grease

OS7136
OS7141
OS7142

AVOID INJURY. Read 

and understand the entire Safety 
section before proceeding.