Ariens 921013 Benutzerhandbuch

GB - 23

To travel from one work area to another:

1. Set Throttle to Slow or Part-Throttle 

position.

2.

: Press 

down on handlebars enough to raise 
front of unit slightly off surface. 

: Place the unit in the transport 

position (see Track Angle on page 20).

3. Engage wheel or track drive clutch 

without engaging attachment drive 
clutch.

ALWAYS shut off engine, remove key, and 
close fuel shut-off valve when transporting 
unit on a truck or trailer.
Use extra care when loading or unloading 
unit onto trailer or truck.
Secure unit chassis to transport vehicle. 
NEVER secure from rods or linkages that 
could be damaged.
DO NOT transport machine while engine is 
running.

Ariens Dealers will provide any service or 
adjustments which may be required to keep 
your unit operating at peak efficiency. Should 
engine service be required, contact an Ariens 
dealer or an authorized engine 
manufacturer's service center.

1. Shut off engine, remove key, disconnect 

spark plug wire and allow unit to cool 
completely.

2. Close fuel shut-off valve (see Fuel Shut-

3. Drain fuel tank and fuel system (see 

Engine Manual for complete 
instructions).

4. Place unit on a flat level surface. Tip unit 

forward onto front of auger housing for 
service. 

Ensure unit is secure and will 

not tip over. Strap and clamp onto bench if 
needed.

AVOID INJURY. Read 

and understand the entire Safety 
section before proceeding.

Before tipping unit up 

onto housing, remove fuel so no 
spills will occur . Ensure unit is 
secure and will not tip over during 
maintenance.

Figure 23

OS7121