Ariens 921013 Benutzerhandbuch

GB - 28

If chute does not rotate freely:
Tighten the cable by loosening the forward 
adjustment nut, and then tightening the rear 
adjustment nut against the bracket until all 
cable slack is removed (Figure 30).

(Figure 31)
Deflector must stay in selected position while 
blowing snow.
To adjust, loosen then retighten hardware to 
desired deflection drag force (Figure 31).

(Figure 32)
If discharge chute does not stay in position 
while operating, tighten nut on carriage bolt at 
pivot point to increase tension on spring.

(Figure 33)
To adjust:

1. Disconnect adjustment pivot pin from 

speed selector lever by removing 
hairpin.

2. Place the speed selector on the dash in 

the fastest forward speed position.

3. Turn the speed selector lever straight 

down towards the ground as far as it will 
go.

4. Thread the adjustment pivot pin along 

the shift rod until it aligns with the mating 
hole on the speed selector lever. Insert 
the pivot pin into hole.

5. Secure adjustment pivot pin with hairpin.
6. Make sure the speed selector shifts into 

each speed position.

7. Check forward and reverse speeds:

a. Start unit.
b. Shift speed selector into the first 

forward speed.

Adjusting 
Hardware

Figure 31

OS7176

Discharge Chute 
Deflector

Discharge 
Chute

Figure 32

OS7177

1. Spring
2. Nut