Cub Cadet 1130 SWE Benutzerhandbuch

5

NOTE: Any reference in this manual to the left or right
side of the snow thrower is observed from the
operator’s position.

•

Remove screws from the top sides and ends of the 
shipping crate.

•

Set panel aside to avoid tire punctures or personal 
injury.

•

Remove and discard plastic bag that covers unit.

•

Remove any loose parts included with unit (i.e., 
Operator’s Manual, etc).

•

Roll unit out of crate.

The augers are secured to the auger shaft with two 
shear bolts and hex lock nuts. If you hit a foreign object 
or ice jam, the snow thrower is designed so that the 
bolts may shear. Two replacement shear bolts and nuts 
are provided for your convenience. Store in a safe 
place until needed. See Figure 1.

•

Remove the lower two plastic wing nuts, cupped 
washers and carriage bolts from each side of the 
lower handle. See  Figure 2.

•

Raise the upper handle assembly until it locks over 
the lower handle.

•

Look at the lower rear of the snow thrower frame to 
be sure all the cables are aligned with the cable 
roller guides.

•

Secure the upper handle and lower handle with the 
two plastic wing nuts, cupped washers and carriage 
bolts previously removed and tighten the upper two 
plastic wing nuts. See Figure 3.  

•

Slide the shift rod connector down over the end of 
the lower shift rod. Tap the connector until it locks 
over the lower shift rod. See Figure 3.

NOTE: If the connector is not properly assembled, the
shift rod will pivot and you will not be able to change
speeds or change directions.

•

If not already attached, slip the cables that run from 
the handle panel to the chute into the cable guide 
located on top of the engine. See Figure 4.

•

Unwrap the headlight wire, which is attached to the 
headlight beneath the handle panel.

•

Wind the headlight wire around the right handle 
until excess slack is removed. 

•

Plug the wire from the headlight into the wire lead 
coming from the right side of the engine, beneath 
the fuel tank.