Cub Cadet 221 HP Benutzerhandbuch

One Snow Thrower

• 

One Chute Assembly

• 

Two Ignition Keys

• 

One 3-Prong Extension Cord

• 

One 20 oz. Bottle 5W-30 Oil

• 

One Snow Thrower Operator’s Manual

• 

One Engine Operator’s Manual

• 

NOTE: All references to the left or right side of the snow thrower 

are from the operator’s position. Any exceptions will be noted.

Open the top of the carton.

1. 

Cut down the corners on the front of the carton and fold 

2. 

down the front side.
Pull the snow thrower out of the carton. Be sure not to 

3. 

damage the chute, or any cables attached to the chute. The 

chute is shipped under the shroud on the back side of the 

carton.  Check for any cable ties securing the chute and 

remove if necessary.

Refer to the Engine Operator’s Manual packed with your snow 

thrower for information on adding fuel and oil.

Remove the wing knob and carriage bolt from the top of 

1. 

the lower handle. See Fig. 3-1. It is not necessary to remove 

the shoulder screw and flange lock nut below the wing 

knob and carriage bolt.

Pivot the upper handle into the operating position. Be sure 

2. 

not to pinch any of the cables in the process. See Fig. 3-2.

Tighten the previously removed hardware  to secure the 

3. 

handle in place. See Fig. 3-2.