Cub Cadet 730 STE Benutzerhandbuch
12
Shift Rod Adjustment
To adjust the shift rod, proceed as follows:
•
Remove the hairpin clip and slide the shift rod
connector up, to separate the upper shift rod from
the lower shift rod. See Figure 11.
connector up, to separate the upper shift rod from
the lower shift rod. See Figure 11.
•
Place the shift lever into the sixth (6) position.
•
Rotate the shift arm clockwise (from the operator’s
position) as far as it will go.
position) as far as it will go.
•
Thread the upper shift rod downward until the
elbow on its lower end aligns with the hole found in
the lower shift rod.
elbow on its lower end aligns with the hole found in
the lower shift rod.
Figure 11
•
Reconnect the upper shift rod to the lower shift rod
by reinserting the hairpin clip removed earlier and
sliding the shift rod connector back down into place.
by reinserting the hairpin clip removed earlier and
sliding the shift rod connector back down into place.
IMPORTANT:
Make certain to check for correct
adjustment of the shift rod as instructed under Final
Adjustments in the Assembly Section, before operating
the snow thrower.
Adjustments in the Assembly Section, before operating
the snow thrower.
Skid Shoes
The space between the shave plate and the ground can
be adjusted.
be adjusted.
•
For close snow removal on a smooth surface, raise
skid shoes higher on the auger housing.
skid shoes higher on the auger housing.
•
Use a middle or lower position when the area to be
cleared is uneven.
cleared is uneven.
•
Adjust skid shoes by loosening the flange lock nuts
and carriage bolts. Move skid shoes to desired
position. See Figure 12.
and carriage bolts. Move skid shoes to desired
position. See Figure 12.
Figure 12
•
Make certain the entire bottom surface of skid shoe
is against the ground to avoid uneven wear on the
skid shoes. Retighten nuts and bolts securely.
is against the ground to avoid uneven wear on the
skid shoes. Retighten nuts and bolts securely.
•
Repeat on the other side of the snow thrower.
WARNING:
Do not operate this snow
thrower on gravel as loose gravel can be
easily picked up and thrown by the auger
causing injury to the operator and/or
damage to the snow thrower.
easily picked up and thrown by the auger
causing injury to the operator and/or
damage to the snow thrower.
Carburetor
•
Minor carburetor adjustment may be required to
compensate for differences in fuel, temperature,
altitude and load.
compensate for differences in fuel, temperature,
altitude and load.
•
Refer to the separate engine manual, packed with
your unit, for carburetor adjustment information.
your unit, for carburetor adjustment information.
SECTION 5: MAINTAINING YOUR SNOW THROWER
WARNING:
Before lubricating, repairing, or
inspecting, disengage all clutch levers and
stop engine. Wait until all moving parts have
come to a complete stop. Disconnect spark
plug wire and ground it against the engine to
prevent unintended starting. Always wear
safety glasses during operation or while
performing any adjustments or repairs.
stop engine. Wait until all moving parts have
come to a complete stop. Disconnect spark
plug wire and ground it against the engine to
prevent unintended starting. Always wear
safety glasses during operation or while
performing any adjustments or repairs.
Lubrication
Engine
Refer to the separate engine manual packed with your
unit for all engine lubrication instructions.
unit for all engine lubrication instructions.
Shift Lever
Hairpin Clip
Flat
Washer
Washer
Ferrule
Upper Shift Rod
Hairpin Clip
Lower Shift Rod
Shift Arm
Shift Rod
Connector
Connector