Cub Cadet 730 STE Benutzerhandbuch

6

•

If not already attached, unwrap the headlight wire 
which is attached to the headlight, beneath the 
handle panel. Wind the headlight wire around the 
lower right handle until excess slack is removed. 
See Figure 4.

•

Plug the wire from the headlight into the alternator 
lead coming from the right side of the engine 
underneath the fuel tank.

•

This tool, along with the electric cord, is fastened 
with a cable tie to the rear of the auger housing for 
shipping purposes. Cut the cable tie and remove 
the electric cord before operating the snow thrower.

Read, understand, and follow 

all instructions and warnings on the machine 
and in this manual before operating.

The drive control is located on the right handle. 
Squeeze the drive control to engage the wheel drive. 
Release to stop. See Figure 5.

NOTE:

 Wheels are omitted from illustration for clarity.