Cub Cadet 728 TDE Benutzerhandbuch

NOTE: It is not necessary to remove both belts in order to change 

either one. If changing just one belt, be certain to check the 

condition of the other belt.
1. 

Allow the engine to run until it is out of fuel. Do not 

attempt to pour fuel from the engine. Remove the key to 

avoid unintended starting.

2. 

Remove the plastic belt cover at the front of the engine by 

removing the two self-tapping screws. See Figure 7-1.

3. 

Tip the snow thrower up and forward so that it rests on its 

auger housing.

4. 

Remove the frame cover from the underside of the snow 

thrower by removing the self-tapping screws which secure 

it. See Figure 7-2.

NOTE: Tracks removed for clarity

5. 

Roll the auger belt off the engine pulley. See Figure 7-3.