Cub Cadet 728 TDE Benutzerhandbuch

• 

One Snow Thrower

• 

Two Replacement Auger Shear Pins

• 

One Chute Assembly

• 

One Snow Thrower Operator’s 

Manual

• 

One Product Registration Card

• 

One Chute Control Rod

• 

One Engine Manual

1. 

Place the shift lever in the Forward-6 position

2. 

Remove the lower plastic wing nut and carriage bolt from 

each side of the upper handle; then raise the upper handle 

assembly until it snaps over the lower handle. See Figure 

3-1.

NOTE: Make certain the cables are seated properly in the 

roller guides. See Figure 3-2.

3. 

Looking beneath the handle panel, check that all of the 

cables (steering, auger, shift, and drive) are properly routed 

and not pinched or kinked. 

4. 

Secure the handle by tightening the plastic knob located 

on both the left and right sides of the handle. Remove 

and discard any rubber bands, if present. They are for 

packaging purposes only.

1. 

Remove cotter pin, wing nut and hex screw from chute 

control head. Remove clevis pin and bow-tie cotter pin 

from chute support bracket. See Figure 3-3.