Cub Cadet 724WE Benutzerhandbuch

13

The cams on the ends of the control rods which 
interlock the traction drive and auger drive clutches 
must be lubricated at least once a season or every 
twenty-five hours of operation. The cams can be 
accessed beneath the handle panel. Use a multi-
purpose automotive grease.

Lubricate the gear shaft with 6-n-1 grease at least once 
a season or after every 25 hours of operation (available 
at auto parts stores, or order part number 737-0170).

 

Refer to Figure 10.

•

Oil or spray lubricant into plastic wheel bearings 
inside the wheel hubs at least once a season. 
Remove wheels, clean and coat axles with a multi-
purpose automotive grease. See Figure 13.

•

Once a season, remove the shear bolts and oil or 
spray lubricant inside the shear bolt holes while 
rotating the augers by hand to lubricate the shaft. 
Also, grease fittings are located on both bearing 
housings. Lube with a grease gun. See Figure 14.

At least once a season or after every 25 hours of 
operation, remove rear cover. Lubricate any chains, 
sprockets, gears, bearings, shafts, and shifting 
mechanism at least once a season. Use engine oil or a 
spray lubricant. 

 Avoid getting oil on rubber friction wheel 

and aluminum drive plate. Refer to Figure 10.

The spiral on the end of the chute directional control 
and the base of the discharge chute itself should be 
lubed with multi-purpose automotive grease once a 
season. See Figure 15.

The gear case is equipped with a grease fitting on the 
left housing and should be lubricated with Shell Alvania 
grease EPR00, part number 737-0168A every 25 
hours. See Figure 16. 

 Do not overfill the gear case, its capacity 

is 1.5 oz. Damage to the seals could result. Be sure the 
vent plug is free of grease in order to relieve pressure.