Cub Cadet WE 26 Benutzerhandbuch

This Operator’s Manual may cover a range of product 
specifications. Characteristics and features discussed 
and/or illustrated in this manual may not be applicable to 
all models. 

IMPORTANT: Two replacement auger shear pins are 
included with this manual (or stowed in the plastic handle 
panel). Refer to “Augers” section in the Maintenance 
section for more information regarding shear pin replace-
ment.
1.  Remove the unit from the crate or carton. 
2.  Observe the lower area of the snow thrower to be 

sure both cables are aligned with roller guides before 
pivoting handle upward. 
a.  Pull up and back on upper handle as shown in 

Figure 1. Align upper handle with the lower handle. 

b.  Tighten hand knobs securing upper handle to 

lower handle.

3.  Certain units may require assembly of the chute. If this 

is the case, follow steps 4-7 to install the chute. If the 
chute on the unit is attached, proceed to step 8.

4.  Remove wing nut and hex screw from chute control 

assembly and clevis pin and cotter pin from chute 
support bracket. See Figure 2. Position the chute 
assembly (forward-facing) over the chute base. 

5.  Place the 4-way chute control in a centered position. 

See Figure 3.

6.  Place chute assembly onto chute base and secure 

chute control assembly to chute support bracket with 
clevis pin and cotter pin removed earlier. See Figure 4.

7.  Finish securing chute control assembly to chute 

support bracket with wing nut and hex screw removed 
earlier. See Figure 5.

8.  Check that all cables are properly routed through the 

cable guide on top of the engine. See Figure 6.

9.  The extension cord is fastened with a cable tie to the 

rear of the auger housing for shipping purposes. Cut 
the cable tie and remove it before operating the unit.

B

A