Snapper 17524E Benutzerhandbuch

17

Regular

Maintenance

1. Place the snowthrower on a level surface.

2. Remove the pipe plug (Figure 12). 

3.  Check the lubricant level. It should be level with the

lower edge of the plug opening. If not, add Benalene
900 grease (available from your dealer).

4. Re-install pipe plug, and tighten securely.

The air pressure in each tire (Figure 11) should be 20 psi
(1,36 kPa) and should be equal for both tires for best
performance. Be sure to keep caps on valves to prevent
entry of debris into the valve stem when tires are filled.

Check auger gear case lubrication.**

Lubricate snowthrower.

Check tire pressure.

Change engine oil.*

✛

Clean or replace spark plug.

✛

Check drive linkage/belt tension.

Lubricate Axle Shafts.

Check / Lubricate Free-Hand Linkage.

Lubricate Auger Shaft. ***

25 Hours

10 Hours

Monthly

50 Hours

✛

Yearly

4-6 Hours

Yearly

10 Hours

10 Hours

Benalene 900 

Grease

10W Oil  and Grease

20 psi (1.37 bar)

See Engine Manual

See Engine Manual

N/A

Lithium Grease

10W Oil

Lithium Grease

* Change original oil after two hours of operation.

** Check oil level each fall and spring.

***Lubricate each fall and spring.
✛ See your engine Owner’s Manual.