Snapper EI7243 Benutzerhandbuch

 

 

To retain the quality of the snow thrower, use only 
genuine SNAPPER replacement parts. Contact a 
local SNAPPER dealer for parts and service 
assistance. For the correct part or information for a 
particular snow thrower, always mention model and 
serial number. 

 
3.2  SERVICE - AFTER FIRST 5 HOURS 
 

3.2.1  CHECK AUGER DRIVE BELT  
1.  Visually check engine drive belt for cracking, 
fraying, severed or belt strands exposed. Replace belt 
before operating snow thrower. See Figure 3.1 

 

3.2.2  CHECK WHEEL DRIVE BELT 
1.  Visually check wheel drive belt for cracking, 
fraying, severed or belt strands exposed. Replace belt 
before operating snow thrower. See Figure 3.1. 

 

 

 
 
 
 
 

Lubricate machine as instructed before and after 
operation each season. 
 
3.3.1.  GEAR CASE, AUGER SHAFT and AUGER 

 
1. Before each season of operation, apply two 
shots of grease (Snapper suggests using Benelene 
900) from a grease gun into gear case. The grease 
fitting for the gear case is located in front of the 
gear case. See Figure 3.2. 
2. Before each season of operation, apply two 
shots of grease (Snapper suggests using Benelene 
900) from a grease gun into auger bearing. The 
grease fitting for the auger bearing is located on 
each end of the auger. See Figure 3.2. 
3. Before each season of operation, apply two 
shots of grease (Snapper suggests using Benelene 
900) from a grease gun into the auger shaft. The 
grease fitting for the auger shaft is located in the 
middle of each auger. Remove shear bolts and 
rotate auger to distribute grease evenly around 
shaft. Reinstall shear bolts and nuts. Tighten to 5 to 
10 ft. lb. of torque. See Figure 3.2. 

 
 

 

3.3.2. GENERAL LUBRICATION 
After each season of operation, spread a small 
amount of grease on: The axle shafts for easy 
wheel removal. The discharge chute and mounting 
flange retainers for smooth rotation.