Troy-Bilt 726 TDE Benutzerhandbuch

NOTE: When lubricating the hex shaft, be careful not to get 

any oil on the aluminum drive plate or the rubber friction 

wheel. Doing so will hinder the snow thrower’s drive 

system. Wipe off any excess or spilled oil.

At least once a season, remove the shear pins from the auger 

shaft. Spray lubricant inside the shaft and around the spacers and 

the flange bearings found at either end of the shaft. 

See Fig. 6-4.

If the full range of speeds (forward and reverse) cannot be 

achieved adjust the shift cable as follows:

Place the shift lever in the fastest forward speed position.

1. 

Loosen the hex  nut on the shift cable index bracket. See 

2. 

Fig. 6-5.

Pivot the bracket downward to take up slack in the cable. 

3. 

Retighten the hex nut.

4. 

Refer to the Assembly and Set-up section for instructions on 

adjusting the auger control cable.

Refer to the Assembly and Set-up section for instructions on 

adjusting the skid shoes.