Troy-Bilt 772C0767 Benutzerhandbuch

8

On models so equipped, the fuel shut-off valve, located 
under fuel tank, controls fuel-flow from the fuel tank to 
the engine. See Figure 6.

The safety ignition key must be fully inserted and 
snapped in place before the unit will start. Remove the 
ignition key to prevent unauthorized use of equipment. 
See Figure 6.

 Do NOT attempt to turn the key.

The headlight is on whenever the engine is running.

The track lock lever is located on the right side of the 
snow thrower and is used to select the position of the 
auger housing and the method of track operation. Move 
the lever to the right, then forward or backward to one of 
the three positions. See Figure 7.

Keeps the front end of the snow thrower up 

for easy transport. May also be used on many gravel 
driveways to clear snow while leaving gravel 
undisturbed.

Allows the tracks to be suspended 

independently for continuous ground contact.

Locks the front end of the snow thrower 

down to the ground for hard-packed or icy snow 
conditions.

Read, understand, and follow 

all instructions and warnings on the machine 
and in this manual before operating.

Service the engine with gasoline and oil as 
instructed in the separate engine manual packed with 
your snow thrower. Read instructions carefully.

Use extreme care when 

handling gasoline. Gasoline is extremely 
flammable and the vapors are explosive. 
Never fuel machine indoors or while the 
engine is hot or running. Extinguish 
cigarettes, cigars, pipes and other sources of 
ignition.

NOTE:  If unit shows any sign of motion (drive or
augers) with the clutch grips disengaged, shut engine
off immediately. Readjust as instructed in the Final
Adjustments in the Assembly Section.

•

Attach spark plug wire to spark plug. Make certain 
the metal loop on end of the spark plug wire (inside 
the boot) is fastened securely over the metal tip on 
the spark plug.

•

Make certain the fuel shut-off valve, if so equipped, 
is in the OPEN (vertical) position.

•

Make certain the auger and drive controls are in the 
disengaged (up) position.

•

Move throttle control up to FAST position. Insert 
ignition key into slot and snap in place. See Figure 
6. Be certain it snaps into place. Do not turn key. 

NOTE:  Engine will not start unless ignition key is
inserted into ignition slot in carburetor cover. 

•

Determine that your house wiring is a three-wire 
grounded system. Ask a licensed electrician if you 
are not certain.

•

If your house wiring system is not a three-wire 
grounded system, do not use this electric starter 
under any conditions.