Troy-Bilt 9528 Benutzerhandbuch

13

Never attempt to make any

adjustments while the engine is running,
except where specified in operator’s manual.

If the full range of speeds (forward and reverse) cannot 
be achieved, refer to the figures to the right and adjust 
the shift rod as follows:

1.

Place the shift lever in the fastest forward speed 
position and remove the hairpin clip which secures 
the ferrule to the shift lever.

2.

Rotate the shift arm clockwise as far as it will go. 

3.

Thread the ferrule up or down the shift rod until it 
aligns with the hole in the shift lever. Resecure the 
ferrule with the hairpin clip removed earlier.

Refer to Auger Control Test on Page 11 to adjust the auger 
control.

•

Before operating, check tire pressure and reduce 
pressure to between 15 psi and 20 psi.