Troy-Bilt 2100 Benutzerhandbuch

Before Servicing, repairing or 

inspecting the snow thrower, disengage the auger 

control. Stop the engine and remove the key to 

prevent unintended starting.

To check the adjustment of the shave plate, place the 

1. 

machine on a level surface. The wheels, shave plate and 

augers should all contact the level surface. Note that if the 

shave plate is adjusted too high, snow may blow under the 

housing. If the shave plate wears out excessively, or the 

snow thrower does not self-propel, the shave plate may be 

too low and needs to be adjusted.
NOTE: On new snow throwers or machines with a new 

shave plate installed, the augers may be slightly off the 

ground.
To adjust the shave plate, tip the snow thrower back so that 

2. 

it rests on the handle. Loosen the four lock nuts and bolts 

which secure the shave plate to the housing. See Fig. 6-1. 

Move the shave plate to the desired position and retighten 

the nuts and bolts securely.

As a result of both the control cable and the auger drive belt 

stretching due to wear, periodic adjustments may be necessary. If 

the auger seems to hesitate when rotating, proceed as follows:
The upper hole in the control handle provides for an adjustment 

in cable tension. To adjust, disconnect the end of control cable 

from the bottom hole in the control handle and reinsert it in the 

upper hole. Insert the cable from the outside as shown in Fig. 6-2.

 Test the snow thrower to see if there is a noticeable difference. If 

after the adjustment to the control cable the auger still hesitates 

when rotatiing, see the Service Section for instructions on 

replacing the belt.

Refer to the Assembly and Set-Up section for instructions on 

adjusting the chute assembly.

Lubricate the pivot points on the control handle and the 

extension spring at the end of the control cable with a light 

oil once every season and before the snow thrower is put into 

storage at the end of the season.

If the snow thrower will not be used for 30 days or longer, follow 

the instructions below. 

Store the equipment in a clean, dry area.

1. 

If storing the snow thrower in an unventilated area, rustproof 

2. 

the machine using a light oil or silicone to coat the snow 

thrower.
Clean the exterior of the engine and the snow thrower.

3.