Troy-Bilt 13045 Benutzerhandbuch
13
Adjust skid shoes as follows:
•
Loosen, but do not remove, the three hex nuts
which fasten the skid shoe to the auger housing.
which fasten the skid shoe to the auger housing.
•
Raise or lower the skid shoe to desired position.
•
Retighten the hex nuts loosened earlier.
•
Repeat on the other side of the snow thrower.
NOTE: Make certain the bottom surface of skid shoe is
flat against the ground to avoid uneven wear.
flat against the ground to avoid uneven wear.
Figure 13
Chute Assembly
•
The distance snow is thrown can be adjusted by
adjusting the angle of the chute assembly. Refer to
adjusting the angle of the chute assembly. Refer to
Chute Tilt Control
on page 8.
•
The remote chute control cables have been pre-
adjusted at the factory. Move the remote chute
lever on the control panel back and forward to
adjust angle of the chute assembly.
adjusted at the factory. Move the remote chute
lever on the control panel back and forward to
adjust angle of the chute assembly.
SECTION 6: MAINTAINING YOUR SNOW THROWER
WARNING:
Before lubricating, repairing, or
inspecting, disengage all clutch levers and
stop engine. Wait until all moving parts have
come to a complete stop. Disconnect the
spark plug wire and ground it against the
engine to prevent unintended starting.
stop engine. Wait until all moving parts have
come to a complete stop. Disconnect the
spark plug wire and ground it against the
engine to prevent unintended starting.
General Recommendations
•
Always observe safety rules when performing any
maintenance.
maintenance.
•
The warranty on this snow thrower does not cover
items that have been subjected to operator abuse
or negligence.
items that have been subjected to operator abuse
or negligence.
•
Some adjustments will have to be made
periodically to maintain your unit properly.
periodically to maintain your unit properly.
•
All adjustments in the service and adjustments
sections of this manual should be checked at least
once each season.
sections of this manual should be checked at least
once each season.
•
Follow the maintenance schedule given below.
•
Periodically check all fasteners and hardware to
make sure these are tight.
make sure these are tight.
Check V-Belts
Follow the instructions below to check the condition of
the drive belts every 50 hours of operation.
the drive belts every 50 hours of operation.
•
Remove the plastic belt cover on the front of the
engine by removing the three self-tapping screws.
engine by removing the three self-tapping screws.
•
Visually inspect for frayed, cracked, or excessively
worn out belts.
worn out belts.
•
Replace belts as necessary as outlined in
SERVICING
YOUR SNOW THROWER
.
Lubrication
Auger Shaft
•
At least once a season, remove the shear bolts
from the auger shaft and spray lubricant inside the
shaft. See Figure 14.
from the auger shaft and spray lubricant inside the
shaft. See Figure 14.
•
Grease fittings can be found at either end of the
auger shaft. Lubricate with a grease gun once a
season. See Figure 14.
auger shaft. Lubricate with a grease gun once a
season. See Figure 14.
Gear Case
The auger gear case is equipped with a grease fitting.
Lubricate with Shell Alvania lead-free grease once a
season (order part number 737-0168). See Figure 14.
Lubricate with Shell Alvania lead-free grease once a
season (order part number 737-0168). See Figure 14.
High
Hex Nuts
Carriage Bolts
Skid
Low
Shave Plate
Shoes