Troy-Bilt 2690 Benutzerhandbuch

Place the shift lever in the Forward-6 position

1. 

Remove the lower plastic wing nut and carriage bolt from 

2. 

each side of the upper handle; then raise the upper handle 

assembly until it snaps over the lower handle. See Figure 

3-1.

Looking beneath the handle panel, check that all of the 

3. 

cables (steering, auger, shift, and drive) are properly routed 

and not pinched or kinked. 
NOTE: Make certain the upper ends of each cable are 

seated properly in the proper brackets.
Secure the handle by tightening the plastic knob located 

4. 

on both the left and right sides of the handle. Remove 

and discard any rubber bands, if present. They are for 

packaging purposes only.

Two Ignition Keys

• 

One Snow Thrower

• 

One Chute Assembly

• 

One 110V Extension Cord

• 

One Snow Thrower Operator’s 

• 

Manual

Remove wing nut and hex screw from chute control 

1. 

assembly and clevis pin and cotter pin from chute support 

bracket. Position the chute assembly (forward-facing) over 

the chute base. See Fig. 3-2.