Generac 005982-0 Benutzerhandbuch

Seite von 20
12
3.7  LONG TERM STORAGE
It is important to prevent gum deposits from forming in essential 
fuel system parts such as the carburetor, fuel hose or tank during 
storage. Also, experience indicates that alcohol-blended fuels 
(called gasohol, ethanol or methanol) can attract moisture, which 
leads to separation and formation of acids during storage. Acidic 
gas can damage the fuel system of an engine while in storage.
To avoid engine problems, the fuel system should be emptied 
before storage of 30 days or longer, as follows:
Remove all gasoline from the fuel tank.
• 
 Drain fuel into approved container outdoors, 
away from open flame. Be sure engine is 
cool. Do not smoke near fuel.
Start and run engine until engine stops from lack of fuel.
• 
Drain oil from crankcase after the engine cools down. Refill with 
• 
recommended grade.
Remove spark plug and pour about 1/2 ounce (15 ml) of engine 
• 
oil into the cylinder. Cover spark plug hole with rag. Pull the 
recoil starter a couple times to lubricate the piston rings and 
cylinder bore.
n
 Avoid spray from spark plug hole when 
cranking engine.
Install and tighten spark plug. Do not connect spark plug wire.
• 
Clean the generator outer surfaces. Check that cooling air slots 
• 
and openings on generator are open and unobstructed.
Store the unit in a clean, dry place.
• 
3.8  OTHER STORAGE TIPS
Do not store gasoline from one season to another.
• 
Replace the gasoline can if it starts to rust. Rust and/or dirt in 
• 
the gasoline will cause problems with the carburetor and fuel 
system.
If possible, store the unit indoors and cover it to give protection 
• 
from dust and dirt. BE SURE TO EMPTY THE FUEL TANK.
If it is not practical to empty the fuel tank and the unit is to 
• 
be stored for some time, use a commercially available fuel 
stabilizer added to the gasoline to increase the life of the 
gasoline.
Cover the unit with a suitable protective cover that does not 
• 
retain moisture.
n
 NEVER cover the generator while engine and 
exhaust area are warm.
Maintenance