Petsafe pbc12104 Benutzerhandbuch

Seite von 44
4 www.petsafe.net 
Inserting the battery
The battery compartment is on the same side as the fi ll-up valve (N). Remove the battery 
cover by twisting it and insert the 3-volt battery (the + end fi rst) (O). Twist the cover back on 
(a coin can be used to help you remove and put back the cover) (P).
N
O
P
Note: If the red light fl ickers three consecutive times, the collar battery is low and needs to be changed.
Turning on the device
To turn on the device, press the grey button on the front of the device 
(Q). The green light will fl ash once, indicating the power is on; the green 
light will fl icker every few seconds. Your device, already preset in short 
spray mode, is now ready to function. To change to a longer spray, press 
the same grey button once. The green light will fl ash twice to confi rm the 
new spray setting. To go back to the shorter spray, press the button
Q
once again. The green light will fl ash once to confi rm the change. You can switch spray 
settings at will by simply pressing the grey button.
Turning off the device
To turn off the device, press the grey button until the red light fl ashes twice. The green light 
will no longer fl icker.
Note: Before every use, it is best to test the device by blowing into the microphone.
Adjust the spray collar onto the dog’s neck with the on/off button facing 
outward and the fi ll-up valve and battery cover facing downward (R).
Your Anti-Bark Spray Collar
 will now react when your dog barks. 
Training, in addition to the use of the device, will accelerate and 
consolidate the desired behavior (behaviour) modifi cation.
R
Do’s and Don’ts
• The collar should be worn only during periods of nuisance barking and no more than 
eight hours per day.
• The collar must be fi lled to maximum capacity before placing it around your dog’s neck.
• Never fi ll the device while your dog is wearing it because it may damage the fi ll-up valve.
• To ensure that your dog does not make the connection between you and the spray collar, don’t let 
him see you prepare the device, neither for the fi rst try, nor for subsequent use. Keep your dog 
away while you prepare the device as well as when you fi ll it or change the battery. A B C
• It is important that your dog’s hair doesn’t block the spray valve. Try tying a bandanna 
(handkerchief) around your dog’s neck, then place the spray collar over. If necessary, you may 
also consider trimming a little of the long hair around the dog’s throat for better spray effect.
• Remove all other collars with metallic parts or tags. These could create noise that may needlessly 
activate the spraying device.
• Never fasten a leash (lead) to the Anti-Bark Spray Collar.
• Avoid letting your dog wear the device with an empty reservoir. Make sure it is always full.
• Turn OFF the device while not in use.
• The system should only be used with pets who are over 6 months of age.  If your pet is injured or 
its mobility is otherwise impaired, contact your veterinarian or professional trainer before use.