Korg PA50 Benutzerhandbuch

Seite von 248
199
Effects
Mod./P.Shift
038: PitchShift
(Pitch Shifter)
This effect changes the pitch of the input signal. You can
select from three types: Fast (quick response), Medium, and
Slow (preserves tonal quality). You can also create an effect in
which the pitch is gradually raised (or dropped) using the
delay with feedback.
a: Mode
This parameter switches the pitch shifter operating mode.
With  Slow, tonal quality will not be changed too much.
With  Fast, the effect becomes a Pitch Shifter that has a
quick response, but may change the tone. Medium is in
between these two. If you do not need to set too much
pitch shift amount, set this parameter to Slow. If you wish
to change the pitch significantly, use Fast.
b: Pitch Shift [1/2tone], b: Src, b: Amt, c: Fine [cent], c: Amt
The amount of pitch shift will use the value of the “Pitch
Shift” plus the “Fine” value. The amount of modulation
will use the c: Amt value plus d: “Amt.”
Modulation Source is used both for “Pitch Shift” and
“Fine.”
e: Feedback Position, f: Feedback
When “Feedback Position” is set to Pre, the pitch shifter
output is again input to the pitch shifter. Therefore, if you
specify a higher value for the Feedback parameter, the
pitch will be raised (or lowered) more and more each time
feedback is repeated.
If “Feedback Position” is set to Post, the feedback signal
will not pass through the pitch shifter again. Even if you
specify a higher value for the Feedback parameter, the
pitch-shifted sound will be repeated at the same pitch.
a
Mode
Slow, Medium, Fast
Switches Pitch Shifter mode
b
Pitch Shift [1/2tone]
–24...+24
Sets the pitch shift amount by steps of a semitone
,
 
Src
Off...Tempo
Selects the modulation source of pitch shift amount
Amt
Sets the modulation amount of pitch shift amount
–24...+24
c
Fine [cent]
Sets the pitch shift amount by steps of a cent
–100...+100cent
,
Amt
Sets the modulation amount of pitch shift amount
–100...+100cent
d
Delay Time [msec]
Sets the delay time
0...1000msec
e
Feedback Position
Switches the feedback connection.
Pre, Post
f
Feedback
Sets the feedback amount
–100...+100
High Damp [%]
Sets the damping amount in the high range
0...100%
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out  /  Dry: Stereo In - Stereo Out
Input Level
Input Level
+
High Damp
Delay
Feedback
Pitch Shifter
Feedback Position
Pre
Post
g
Input Level Dmod [%]
–100...+100
Sets the modulation amount of the input level
 Fx:037,
Src
Selects the modulation source for the input level
Off...Tempo
 Fx:037
h
Wet/Dry
Dry, 1:99...99:1, Wet
Src
Off...Tempo
–100...+100