Panasonic AV-HS410N Benutzerhandbuch

10

 Handle carefully.

   Do not drop the product, or subject it to strong shock or 

vibration.  
Do not carry or move the product by the fader lever. This is 
important to prevent malfunctioning or accidents.

  Use the product in an ambient 

   Avoid using the product at a cold place below 0 °C (32 °F) 

or at a hot place above 40 °C (104 °F) because extremely 
low or high temperature will adversely affect the parts 
inside.

  Power off before connecting or 

   Before plugging or unplugging the cables, be sure to switch 

power off.

  Avoid humidity and dust.

   Avoid using the product at a humid, dusty place because 

much humidity and dust will cause damage to the parts 
inside.

  Maintenance

   Turn off the unit’s power and wipe the product using a dry 

cloth. To remove stubborn dirt, dip a cloth into a diluted 
solution of kitchen detergent (neutral), wring it out well, and 
wipe the product gently. Then, after wiping the product with 
a moist cloth, wipe it again with a dry cloth.

•  Avoid using benzine, paint thinners and other volatile 

fluids.

•  If a chemical cleaning cloth is to be used, carefully 

read through the precautions for its use.

  Precaution to be observed during 

   This product’s image switching and image effect functions 

can be used to produce images which flicker rapidly or 
images which change rapidly.

   However, bear in mind when using these functions in 

production that the kinds of images produced may have an 
adverse effect on the viewer’s physical well‑being.

 Built-in display (LCD monitor)

   Leaving the built‑in display on with the same image over 

a long period of time may result in temporary afterimage 
(burn‑in).

   Such afterimages are usually resolved when ordinary 

moving images are displayed for a while.

   The liquid crystal parts are highly precise with 99.99 % of 

the pixels effective. This leaves less than 0.01 % of pixels 
that may not light or may remain on all the time.

   These phenomena are normal and will have no effect on 

the images you shoot.

   Condensation may form if you use the unit where 

temperatures fluctuate. Wipe dry with a soft, dry cloth.

   When the unit has completely cooled down, the display 

on the LCD monitor appears slightly darker than usual 
immediately after the power has been turned on. Once the 
internal temperature of the unit rises, the display returns to 
the normal brightness.

 When the product is to be discarded

   When the product is to be discarded at the end of its 

service life, ask a specialized contractor to dispose of it 
properly in order to protect the environment.

 Concerning the consumable parts

Cooling fan:
   This is a consumable part. 
   As a general rule, replace it every 5 years or so (when 

the unit has been operated for 15 hours a day).

Power supply unit:
   This is a consumable part. 
   As a general rule, replace it every 5 years or so (when 

the unit has been operated for 15 hours a day).

The period when the consumable parts need to be 
replaced will differ depending on the operating conditions.
When the time comes to replace one of these parts, be 
absolutely sure to ask your dealer to do the job.