Panasonic AV-HS410N Benutzerhandbuch

36

Digital RGB: 
   XGA (1024768), WXGA (1280768), SXGA (12801024), WSXGA+ (16801050), 

UXGA (16001200), WUXGA (19201200)

   Vertical frequency: 60 Hz
Video format inputs:
   Digital RGB: 1080/50p, 1080/59.94p
   Vertical frequency: Same as system formats
Video format outputs:
   Digital RGB: 1080/50p, 1080/59.94p, 1080/50i, 1080/59.94i, 720/50p, 720/59.94p

p

 The input and output of analog signals are not supported.

p

 Output support the high‑resolution multi view mode: 

Signals are output with a high resolution even when SD is set as the system mode. 
(When high‑resolution multi view mode has been enabled, MV is selected as the DVI‑D OUT 
output, and it is not possible to select MV with SDI OUT.)

p

 This connector does not support the HDCP technologies.
Standard input/output: 1 line each (DVI‑D IN, DVI‑D OUT)

p

 The DVI‑I connector cable cannot be used.

p

 For the DVI‑D connector cable, use a cable with a length of up to 5 m (16.4 ft).

In gen‑lock mode: 

Black burst or Tri‑level Sync input signals (with loop‑through)

In internal sync mode: Black burst output signals 2

p

 Same field frequencies as those of the system formats supported.

p

 With the 1080/23.98PsF and 1080/24PsF formats, only gen‑lock mode supported.

p

 With the 1080/23.98PsF format, black burst with 10F‑ID (SMPTE318M standard met) or TRI 

signals supported.

When the frame synchronizer setting is “Off” and the up‑converter setting is 
“Off”.

1 line (H)

When the frame synchronizer setting is “On” or the up‑converter setting is “On”. 1 frame (F)

p

 When the signals have passed through PinP, DVE, multi view, down‑converter, DVI‑IN or  

DVI‑OUT, a maximum delay of 1 frame is applied in each case.

LAN

10BASE‑T/100BASE‑TX (For IP control)
Connecting cable:
   LAN cable (category 5 or above),  

max. 100 m (328 ft), STP (Shielded Twisted 
Pair) cable recommended

p

 When connecting to a hub (switching hub), 

use a straight cable.  
Use a crossover cable when connecting the 
unit and computer on a 1:1 basis without 
going through a hub.

p

 Use with the same segment is recommended 

for the equipment which is connected to the 
unit. 
If the unit is connected to equipment whose 
segments are different, events dependent 
upon the settings inherent to the network 
equipment, for instance, may occur so 
thoroughly check the connections with the 
equipment to which the unit will be connected 
prior to the start of operation.

RJ‑45

EDITOR

Used to control an editor
RS‑422 control connector
Communication format
  Baud rate 

: 38400 bps

  Character length : 8 bit
  Parity 

: Odd

  Stop bit 

: 1 bit

  Flow control 

: None

D‑sub, 9‑pin, female