American Dj Light Station Benutzerhandbuch

also change chase patterns normally. To activate this function press and

release the MANUAL STEP (26) while holding down the SHIFT BUTTON

(16). The LCD DISPLAY (6) MANUAL STEP LED will light, indicating

this function has been activated. To exit this function press the CHASE

BUTTON (24) at any time.

Fade Time Function:

This function can be operated in any normal

chase function. This function allows you to control the amount of time it

takes for one scene to switch off and the next to turn on. Basically one

scene fades to the next. The amount of fade time varies from instant to

10 minutes. This function is controlled by the FADE TIME SLIDER (7) and

only effects the dimmer channels (1-8). When the FADE SLIDER is set

to zero the amount of time it takes for one scene to fade to the next will

be instant, when the fader is set to 10, it will take about 10 minutes to

fade from one scene to the next. To activate this function move the FADE

TIME SLIDER (7) up and down during any normal chase function.

Midi Settings:

This controller can be triggered by any type of MIDI

device. To use the MIDI function, plug in a standard MIDI controller to the

MIDI input jack (35) on the rear of the Light Station.™ When your unit is

receiving a MIDI signal the yellow MIDI SIGNAL LED will begin to flash

rapidly. To operate properly the MIDI input channel must match that of

the controller MIDI receiving channel. The controller’s default MIDI input

signal is one, you may find it necessary to change this setting if you are

running several MIDI devices. To adjust the controllers input MIDI signal

hold down the MIDI CHANNEL BUTTON (27) for two seconds while hold-

ing down the SHIFT BUTTON (16). “CH:01” will appear in the LCD DIS-

PLAY (6). Use the STEP UP and DOWN BUTTONS (20 & 21) to change

the input if necessary. Below you will find the MIDI NOTE DATA:

Note Number

Velocity

Function

22-81

Master Pattern Level

Turns Patterns 1-60 On & Off

82-97 Channel Dimmer

Identical to the Flash Channels 1-16

Full ON

101

Execute the patterns step by step

102

Engages and disengages STAND BY mode

Please note when use a MIDI controller the LEVEL SLIDER (8) will

not function.
Controller Reset and Memory Dump:

This board may be reset

to factory settings at any time. You may use this function to erase all

your programs. This function may also be used to eliminate any system

FREEZE.

Caution: This operation may be harmful to the controllers internal Flash

Memory, please use this operation infrequently.

Options:

An optional foot controller may be purchased separately. This controller

will allow you to control some of the function by remote. With the foot con-

troller you may control pattern step up, pattern up, stand by mode, full on.

Please contact you American DJ dealer for pricing.