Harman 1210KA Benutzerhandbuch
8
Soundcraft EFX/EPM User Guide Issue 1210
OVERVIEW
BANK A
KARAOKE
THE 60-SECOND GUIDE - EFX
1 MIC INPUT (XLR)
Connect Microphones here. If you are using a condenser mic, ensure phantom
power is supplied by pressing the switch at the top of the master section.
power is supplied by pressing the switch at the top of the master section.
WARNING: Do Not apply Phantom Power before connecting a
microphone.
microphone.
2 LINE INPUT (
¼” Jack)
Connect Line level sources here, e.g. Synth, Drum Machine, DI etc.
3 INSERT POINT (
¼” Jack)
Connect Signal processors here, e.g. Compressor, Gate etc.
4 GAIN CONTROL
Adjust this to increase or decrease the level of the incoming signal.
5 EQ STAGE
Adjust these controls to change the signal tone (the character of the signal).
6 AUX 1 SEND
Adjust this control to change the level of the signal to an artist’s monitors
(headphones/in-ear/stage monitors). Aux 1 is globally switchable pre/post
fade.
(headphones/in-ear/stage monitors). Aux 1 is globally switchable pre/post
fade.
7 FX SEND
This control sets the level of the post-fade signal being sent to the FX bus;
from there it is routed to the FX processor.
from there it is routed to the FX processor.
8 PAN CONTROL
Use this control to position the signal within the stereo field.
9 MUTE SWITCH
When this is pressed you will hear no signal from the channel (post-mute
signals).
signals).
10 PFL
When pressed the signal will appear on the monitor and headphone outputs
- use this to monitor the post-EQ signal from the channel.
- use this to monitor the post-EQ signal from the channel.
To get you working as fast as possible, this manual begins with a 60-second guide. Here you can find quick
information on any feature of the EFX console.
information on any feature of the EFX console.