Cub Cadet 190-002 Benutzerhandbuch

22

•

Holding the hitch latches up will allow the tractor, 
with the attachment hitch still mounted, to be 
pushed away from the tiller with the sleeve hitch 
mounted to it. Only push the tractor away a few 
inches.

•

The hydraulic pump assembly is still lying on the 
ground with the hoses attached. Carefully push the 
tractor forward being careful to not damage the 
hoses or hydraulic pump assembly.

•

There is enough clearance under the left side of the 
transmission for the hydraulic pump assembly to 
come out without having to raise the tractor.

The attachment hitch, which has the electric lift cylinder 
attached to it, is still attached to the tractor. To remove 
the attachment hitch it is necessary to first unplug the 
electric lift cylinder from the electric lift harness. This is 
located between the rear fender of the tractor and the 
electric lift cylinder itself. 

It is recommended that the attachment hitch be 
removed during non-tilling usage of the tractor. To 
remove the attachment hitch, proceed as follows: 

•

Follow the wires from the electric lift cylinder until 
the connector is found. Pull the connectors apart.

•

Pull the hairpin clip out of the clevis pin which holds 
the attachment hitch to the hitch plate of the tractor 
and remove the clevis pin. Refer to Figure 11.

•

Using both hands, lift the attachment hitch straight 
up approximately one inch in order to get the 
hanger slots off of the shoulder bolts they are 
resting on. Once this is done, pull the attachment 
hitch away from the machine and set it aside.

 Be certain to store all removed hardware 

in a safe place to insure proper reinstallation later.