Cub Cadet 190-002 Benutzerhandbuch
7
SECTION 3: TO THE OWNER
Model 190-002-100, 30-inch hydraulic tiller attachment is designed for use on Series 2000 Lawn Tractors with 23”
rear tires only. It will NOT fit nor operate properly or safely on ANY other tractor. Using this tiller attachment requires
the use of weight kit bracket 190-307-100 and suitcase weights part number 190-390-100 (three weights required).
rear tires only. It will NOT fit nor operate properly or safely on ANY other tractor. Using this tiller attachment requires
the use of weight kit bracket 190-307-100 and suitcase weights part number 190-390-100 (three weights required).
The instructions in this manual are divided into sections. Carefully read all sections and study the illustrations to
ensure proper installation and usage of this attachment. Read and observe all WARNING and CAUTION
statements. They are included to provide for the protection of the equipment installer and user, and to ensure the
prolonged service life of the equipment.
ensure proper installation and usage of this attachment. Read and observe all WARNING and CAUTION
statements. They are included to provide for the protection of the equipment installer and user, and to ensure the
prolonged service life of the equipment.
References to LEFT and RIGHT indicate the left and right sides of the tractor and tiller attachment when facing
forward in the operator’s position. Reference to the FRONT indicates the grille end of the tractor and reference to
the REAR dictates the drawbar end where the tiller attaches.
forward in the operator’s position. Reference to the FRONT indicates the grille end of the tractor and reference to
the REAR dictates the drawbar end where the tiller attaches.
SECTION 4: LOOSE PARTS
The tiller attachment is shipped with the following loose parts in the crate. Please remove all loose parts from the
crate before discarding it. Refer to Figure 1 to identify the parts, noting that these parts may be referred to again in
the following sections of the manual.
crate before discarding it. Refer to Figure 1 to identify the parts, noting that these parts may be referred to again in
the following sections of the manual.
Figure 1
SECTION 5: ASSEMBLING THE TILLER
Attachment Hitch Assembly
The attachment hitch assembly is shipped with a
separate hardware kit that is needed to mount the
assembly to the tractor. See Figure 1.There is also an
electric wiring harness necessary for the lift operation of
the attachment hitch.
separate hardware kit that is needed to mount the
assembly to the tractor. See Figure 1.There is also an
electric wiring harness necessary for the lift operation of
the attachment hitch.
The attachment hitch assembly is shipped complete.
This assembly includes the electric lift cylinder, a wiring
harness, and an electric switch that will control the lift
cylinder.
This assembly includes the electric lift cylinder, a wiring
harness, and an electric switch that will control the lift
cylinder.
Hydraulic Pump Assembly
The hydraulic pump assembly is shipped together with
a V-belt and a bracket with mounting hardware
attached to it.
a V-belt and a bracket with mounting hardware
attached to it.
The two hydraulic hoses, which are enclosed in a
protective sleeve, are packaged separately from the
hydraulic pump assembly and need to be attached to it.
Both hoses have female connectors on either end and
will attach to male connectors on both the hydraulic
pump assembly and the tiller assembly itself.
protective sleeve, are packaged separately from the
hydraulic pump assembly and need to be attached to it.
Both hoses have female connectors on either end and
will attach to male connectors on both the hydraulic
pump assembly and the tiller assembly itself.
Attachment
Hydraulic Pump Assembly
Hardware Kit
Rear Tine Shield
(for use w/out roller)
Tiller Frame w/Roller
w/ Elect Lift