Troy-Bilt 12212 Benutzerhandbuch
Section 2: Assembly
4. Check the tightness of the upper
mounting screw that secures the negative
cable and starter solenoid to the battery
post. See Figure 2-20. Scrape away any
paint between the cable and the screw as
the paint can prevent a good electrical
ground.
mounting screw that secures the negative
cable and starter solenoid to the battery
post. See Figure 2-20. Scrape away any
paint between the cable and the screw as
the paint can prevent a good electrical
ground.
5. Install one end of the clear plastic vent
tube over the vent fitting (U, Figure 2-21)
on the battery. Insert the other end down
into the vent tube shield (V).
tube over the vent fitting (U, Figure 2-21)
on the battery. Insert the other end down
into the vent tube shield (V).
STEP 4: Connect Wiring Harness
Attach the wiring harness receptacle to
the prongs on the back of the ignition
switch (see Figure 2-22).
the prongs on the back of the ignition
switch (see Figure 2-22).
IMPORTANT: This completes the assem-
bly steps for the electric start tiller. Be
sure to read the rest of this Manual, and
the separate Engine Owner’s Manual,
before you operate your tiller.
bly steps for the electric start tiller. Be
sure to read the rest of this Manual, and
the separate Engine Owner’s Manual,
before you operate your tiller.
12
Figure 2-20: Check tightness of upper mounting screw.
Figure 2-21: Install vent tube.
Figure 2-22: Attach wiring harness to keyswitch.
Keyswitch
Wiring Harness
U
V
Improper venting can cause a battery to
explode, resulting in severe personal
injury or property damage.
explode, resulting in severe personal
injury or property damage.
Be sure that the vent tube does not
become kinked, folded or pinched along
its entire length.
become kinked, folded or pinched along
its entire length.
WARNING