Troy-Bilt 769-03618 Benutzerhandbuch

To prevent personal injury or property 

damage, do not start the engine until all assembly 

steps are complete and you have read and 

understand the safety and operating instructions in 

this manual.

1⁄2” open-end wrench
9⁄16” open-end wrench
3⁄8” open-end wrench
Scissors (to trim plastic ties)
Ruler (for belt tension check)
Block of wood (to support tiller when removing wheels)
Tire pressure gauge (for models with pneumatic tires)
Clean oil funnel
Motor oil. Refer to the Engine Operator’s Manual for oil 

specifications and quantity required.

Hex Screw, 5⁄16-18 x 1-1⁄2”
Hex Screw, 3⁄8-16 x 3⁄4”
Flat Washer, 3⁄8”
Split Lock Washer, 5⁄16”
Hex Nut, 5⁄16”-18
Hex Locknut, 3⁄8”-16

NOTE: While unpacking, do not severely bend any of the control 

cables.

The tiller weighs approximately 133 lbs. Do not attempt to 

remove it from the shipping platform until instructed to do 

so in these assembly steps. 
Remove any packaging material from the carton. Remove 

any staples from the bottom of the carton and remove the 

carton from the shipping platform.
Remove all unassembled parts and the separate hardware 

pack from the carton. Check that you have the items listed 

in the Contents of Carton list (contact your local dealer or 

the factory if items are missing or damaged).

•
•
•
•
•
•
•
•
•

•
•
•
•
•
•

1.

2.

3.

NOTE: All references to the right or left side of the tiller are from 

the operators positon.

Loosely attach the legs of the handlebar support to the 

inner sides of the tiller frame using two 3⁄8”-16 x 3⁄4” hex 

head screws, 3⁄8” flat washers, and 3⁄8”-16 hex locknuts. See 

Fig. 3-1.

1.

One Tiller 

•

One Handlebar Support

•

One Handlebar Assembly

•

One Hardware Pack

•

One Operator’s Manual

•

One Engine Operator’s Manual

•