Sears 917.29425 Benutzerhandbuch

Seite von 21
14
MUFFLER
Do not operate tiller without muffl er. Do 
not tamper with exhaust system. Dam-
aged muf fl ers or spark arresters could 
create a fi re hazard. Inspect pe ri odi cally 
and re place if nec es sary. If your engine is 
equipped with a spark arrester screen as-
 sem bly, re move every 50 hours for clean-
 ing and inspection. Re place if dam aged.
Oil drain
Plug
Oil Fill Plug
CAUTION: Disconnect spark plug 
wire before performing any maintenance 
(except car bu re tor ad just ment) to prevent 
accidental start ing of engine.
Prevent fi res!  Keep the engine free of 
grass, leaves, spilled oil, or fuel.  Re move 
fuel from tank before tipping unit for main-
tenance.  Clean muffl er area of all grass, 
dirt, and debris. 
Do not touch hot muffl er or cylinder fi ns as 
contact may cause burns.
ENGINE
LUBRICATION
Use only high quality detergent oil rated 
with API service classifi cation SF-SJ.  Se-
lect the oil’s SAE vis cos i ty grade accord-
ing to your expected temperature.
NOTE:  Although multi-viscosity oils 
(5W-30, 10W-30, etc.) improve starting in 
cold weather, they will re sult in increased 
oil consumption when used above 40°F 
(4°C).  Check your en gine oil level more 
frequently to avoid pos si ble engine dam-
age from running low on oil.
Change the oil after every 25 hours of 
op er a tion or at least once a year if the tiller 
is not used for 25 hours in one year.
Check the crankcase oil level before 
start ing the engine and after each fi ve (5) 
hours of continuous use.  Add SAE 30 mo-
 tor oil or equivalent.  Tighten oil fi ller plug 
se cure ly each time you check the oil level.
TO CHANGE ENGINE OIL
Determine temperature range expected 
before oil change.  All oil must  meet API 
service classifi cation SF-SJ.
•   Be sure tiller is on level surface.
•   Oil will drain more freely when warm.
•   Use a funnel to prevent oil spill on tiller, 
and catch oil in a suitable con tain er.
1.   Remove drain plug.
2.   Tip tiller forward to drain oil.
3.   After oil has drained completely, 
re place oil drain plug and tighten se-
 cure ly.
4.   Remove oil fi ller plug.  Be careful not to 
allow dirt to enter the engine.
5.   Refi ll engine with oil.  See “CHECK 
EN GINE OIL LEVEL” in the Operation 
section of this manual. 
Oil Level
AIR FILTER 
Your engine will not run properly and may 
be damaged by using a dirty air fi lter. 
Replace the air fi lter every 100 hours of 
operation or every season, whichever oc-
curs fi rst.  Service air cleaner more often 
under dusty conditions.
TO CLEAN AIR FILTER
1.   Remove cover.
2.   Carefully remove cartridge.
3.   Clean by gently tapping on a fl at sur-
face. If very dirty, replace cartridge.
 CAUTION:  Petroleum solvents, such as 
ker o sene, are not to be used to clean car-
 tridge. They may cause de te ri o ra tion of the 
cartridge. Do not oil car tridge. Do not use 
pres sur ized air to clean or dry car tridge.
4.   Install cartridge, then replace cover.
Filter Cover
Latch Tabs
Tabs
Filter