Oregon Scientific WMH800 Benutzerhandbuch

7

.  Press and hold MODE.
2.  Press 

 to change setting options. The settings 

order is: country, city, display contrast, +/-1 time zone, 
12/24 hour format, hour, minute, year, month-day / day-
month, month, day and language.

3.  Press MODE to confirm.

 The language options are English (E), German (D), 

French (F), Italian (I) and Spanish (S).

 If the clock signal is valid, you are unable to 

manually set the time. 

.  Press ALARM to enter Alarm mode. 
 

 indicates in Alarm mode.

2.  Press and hold ALARM to enter settings.
3.  Press 

 to set hour and minute.

4.  Press ALARM to confirm.
5.  Press MODE to return to clock display.

.  Press ALARM to enter Alarm mode.
 

 indicates in Alarm mode.

2.  Press  ALARM repeatedly to activate or deactivate 

alarm.   indicates alarm is On.

3.  Press MODE to confirm and return to clock display.

•  Touch SNOOZE / LIG�T to snooze alarm for 8 minutes
OR
•  Press any key to turn the alarm off and activate it again 

after 24 hours. 

You can adjust the clarity level of the display. Press and hold 
MODE until “CONTR” is shown, then select from 0 (lowest) 
to 5 (highest) by pressing  

  for your preferred level 

of display contrast. Press MODE to confirm.

Touch SNOOZE / LIG�T to activate backlight for 8 seconds 
(only when connected to stand).

Press RESET to return to the default settings.

To mount onto a wall:
Use the hole located at the back of the unit.

 Leave a small gap between the wall and the unit to 

prevent  unit  from  heating  up.    Insufficient  ventilation  may 
distort indoor temperature / humidity readings.

To place on horizontal surface, such as desk:
Align unit with the stand. Place unit downwards and tilt 
slightly backwards to allow unit to lean on the stand.