Ridgid R7130 Benutzerhandbuch

11

Do  not  allow  familiarity  with  tools  to  make  you 
careless. Remember that a careless  fraction of a 
second is sufficient to inflict severe injury.

Always wear safety goggles or safety glasses with 
side shields when operating tools. Failure to do so 
could result in objects being thrown into your eyes 
resulting in possible serious injury.

Do  not  use  any  attachments  or  accessories 
not  recommended  by  the  manufacturer  of  this 
tool. The use of attachments or accessories not 
recommended  can  result  in  serious  personal 
injury.

You may use this tool for the purposes listed below:
n

Drilling in wood

n

Drilling in both hard and soft metals

See Figure 5.
The bail handle may be adjusted to  three positions, depend-
ing on the application and the angle that will give you most 
control and best access to the workpiece.
To set the position of the bail handle:
n

Using a 14 mm wrench, loosen the hex head screw on 
each side of the tool by turning counterclockwise. It is 
not necessary to remove the screws. 

n

Adjust the handle forward or back until the desired posi-
tion is reached. 

n

Tighten the screw on each side by turning the wrench 
clockwise. Do not overtighten.

Fig. 5