Woodstock W1667 Benutzerhandbuch

-16-

1.  Hold onto the table with one hand and

loosen the table lock knob. See Figure 24.

2.  Lift or lower the table to the desired

height, and then position the table so the
opening in the installed table insert is cen-
tered to the drill bit or sanding drum. 

• If the table is not needed, pivot the table

to the back side of the column so you can
support the workpiece on the base
(drilling operations only). See Figure 25.

3.  Tighten the table lock knob.

4.  Loosen the table tilt lock bolt and use the

tilt scale to find your desired drilling or
sanding angle. See 

5.  Tighten the tilt table lock bolt.

You can adjust the table height and angle to

accommodate for workpiece height or achieve
special drilling/sanding angles. You can also
move the table out of the way and use the drill
press base as a table for drilling/sanding.

Figure 24. Support table while loosening lock.

Figure 25. Table adjusted behind column.

Figure 26. Table tilt lock bolt.