Delta N081935 Benutzerhandbuch

12

The table locking wrench can be stored underneath the 
table as shown in Fig. 21.

To attach the belt tension lever handle (II) Fig. 22, place it 
in hole (JJ) with the hole (AA) up, as shown. 

Align set screw (BB) with hole (AA) Fig. 22 and tighten 
screw down into hole firmly with included hex wrench as 
shown in Fig. 23. 

Place M6 x 1 locknut (LL) Fig. 23 on set screw (BB). 
Firmly tighten locknut (LL) with a 10 mm wrench.

The drill press table comes with an insert (XX) Fig. 23B 
made of MDF to help prevent wear and tear on the bit 
when it drills down through the workpiece. 

Over time, it will become necessary to replace this 
piece. It can be made from 3/4" thick MDF cut into a 
3-3/4" square. 

To replace the old insert :
1. Remove two screws from holes (YY) Fig. 23A that 

hold insert in place. 

2.  Remove old insert and place your new insert into the 

table (Fig. 23B).

3.  If the insert is not level with the table, adjust the four 

jack screws (JJ) Fig. 23C. When the table insert is 
level, tighten the locking nut on each screw.

4. Hold down on the insert and secure it in place with 

the 2 screws that were removed in Step 1. Insert 
screws in holes (YY) Fig. 23A and secure insert in 
place.