Sears 200.71206 Benutzerhandbuch

12

Performance problems often result from little  things that you can fix yourself. Please
read through this chart for a possible solution if a problem occurs.

No ammeter reading.

Clamps not making good

connection.

2-amp charge rate.

No AC power reaching charger.

Shorted battery clamps.

Shorted battery.

Charger leads reversed

on battery.

Extension cord too long or

 wire gauge to small.

Battery has weak cell or

sulfated plate.

Battery is only partially

discharged.

Transformer laminations

vibrate (buzz).

Shorted diode (hum).

Circuit breaker in

charger cycles on and

off with a clicking

sound.

Ammeter reads less

than selected charge

rate when charging.

Charger makes a loud

buzz or hum.

If the above solutions do not eliminate the problem...

call toll-free from anywhere in the U.S.A.

1-800-SEARS-64

(1-800-732-7764)

7 AM to 4:30 PM CST Monday through Friday

Have charger tested by qualified

 technician.

Continue charging battery.

Continue charging. Buzz is not

abnormal.

Use shorter or heavier extension cord.

Sulfated battery will eventually take a

normal charge if left connected.  If the

battery will not take a charge, have it

tested by a qualified Sears technician.

Check for poor connection at battery.

Make sure clamps and posts are clean.

Ammeter needle will indicate little activ-

ity at the 2-amp charge rate.

Check AC outlet and extension cords for

loose fitting plug.

Check for open fuse or circuit breaker

supplying AC outlet.

     Separate the clamps. Circuit

      breaker cycles when current

      draw is too high.  Check for worn

      cables and replace if needed.

        Have qualified Sears technician

        test the battery.

        Correct connections.