Digipower TC-370 Merkblatt

 

 

Thank you for purchasing our DigiPower Lithium-Ion 
Ultra Fast Rapid Charger. This unique charger now 
makes it convenient for you charge your batteries with 
almost any AC power source in the World without having 
to add country specific pass through adapters. 
 
The Travel Charger comes equipped with a patented, 
integrated World AC plug that allows you to use your 
Charger around the world in: England, Europe, North 
America, South America, China, Asia, Australia, and 
New Zealand.   
 

 
A.  For Charging Battery Types: 

 

NP-20 or BP-NP20 
NP-40 or BP-NP40 
NP-60 or BP-NP60 
NP-200 or BP-NP200

 

 

1 

The TC -370 Charger is equipped with a battery      
adaptor plate. 
  

2.   This adaptor plate has two sides. 

Each side is labeled with battery types to be used. 

      Side 1 is for NP-40, NP -60 and NP-200 battery types. 

Side 2 is for NP-20 battery type. 
No plate is needed for NP-120 battery type. 
 

3.  The plate can be removed from the charger unit, and 

inserted with either side facing out, depending on the 
type of battery you are charging. 
  

4.  Remove the plate by pushing it out with your thumb or 

finger just above the LED. 
 

5.  When charging any of the batteries listed above (NP-20, 

NP-40, NP-60 or NP-200) you must face the side of the 
adaptor plate labeled with your battery type out and the 
arrow pointing up toward the LED. 
 

6.  You must insert the adaptor plate by placing it almost all 

 the way in and then clicking it into place along the 
 grooves. Then push the plate the rest of the way in so it 
 locks into place. 
 
 
 
 

7.  DO NOT slide the plate all of the way in the charger 

 without first clicking it into the grooves as it will not be 
 set properly and your battery will not charge. 
 

8.  Once you have inserted the plate correctly, you may 

insert your battery for charging.  Make sure to face the 
battery out and have the contacts facing in towards the 
contacts on the charger. 
 

9.  Plug the charger in. 

RED LED = unit is charging battery 
ORANGE LED = trickle charge (battery is 80% full) 
GREEN LED = battery is fully charged  
Allow 2 hours for full charge. 
 

 

NP-120 or BP-NP120

 

1.  Remove adaptor plate from charger. 
2.  Place NP-120 battery in charger with face up 

and contacts facing the contacts in the charger. 

3.  Plug the charger in. 

RED LED = unit is charging battery 
ORANGE LED = trickle charge (battery is 80% full) 
GREEN LED = battery is fully charged  
Allow 2 hours for full charge. 

 

1.  Locate the black button / latch at the base of the 

charger where the North American / Australian 
Plugs are embedded. 

 

2.  Release the North American / Austrailian plug by 

pressing down  on the button / latch. Continue to 
push the North American Plug upward until it is 
in a 90 degree position 
 (Figure A). 

 
 

 

                Figure A 

  

3.  You may now place your Lithuim-Ion battery in 

the charger.   Insert the plug into a wall outlet 
and begin charging your battery.