Grizzly H6231Z 10-TON Benutzerhandbuch
model h6231z (mfg. since 1/10)
-13-
13. thread the 25mm spanner ring onto the
piston housing as shown in
figure 14 until
it is tight. then install the press pin onto the
piston ram.
piston ram.
14. Wearing safety glasses, use a spanner
wrench (or a hammer and a
1
⁄
4
" drift punch)
finish tightening the 25mm spanner ring an
additional
additional
1
⁄
8
turn.
15. Attach the hydraulic pump to the lower pump
bracket with the two m8-1.25 x 25 hex bolts,
two 8mm flat washers, lock washers and hex
nuts, as shown in
two 8mm flat washers, lock washers and hex
nuts, as shown in
figure 15.
figure 14. spanner ring installation.
25mm
spanner
ring
figure 15. pump installation.
hex Bolt
17. remove the plastic caps and connect the
pressure gauge to the top of the piston hous-
ing with a 16mm and 27mm wrench. do not
use teflon tape or thread sealant of any kind
on this type of fitting, as it employs the seal-
ing ring shown in
ing with a 16mm and 27mm wrench. do not
use teflon tape or thread sealant of any kind
on this type of fitting, as it employs the seal-
ing ring shown in
figure 16.
18. remove the plastic caps, connect the pres-
sure line to the piston housing, and thread
the knurled nut onto the self-sealing hydrau-
lic fitting. do not use teflon tape or thread
sealant of any kind on this type of fitting, as
it employs a self-sealing design (see
the knurled nut onto the self-sealing hydrau-
lic fitting. do not use teflon tape or thread
sealant of any kind on this type of fitting, as
it employs a self-sealing design (see
figure
17).
figure 16. hydraulic line installation.
sealing ring
figure 17. hydraulic line installation.
sealed Fit
Knurled
nut
16. place one 8mm lock washer and flat washer
onto the m8-1.25 x 16 hex bolt, and insert it
through the U-beam and tighten it into the
upper pump mounting bracket.
through the U-beam and tighten it into the
upper pump mounting bracket.