Interact-TV 44078 Benutzerhandbuch

Congratulations on your

purchase of the DUCK HUNTER

LAUNCH & LOAD

Do  not  mix  old  and  new  batteries,  different  types  of  batteries,  standard  carbon  zinc,  alkaline  or  rechargeable  of  different  capacities. 

Rechargeable batteries are only to be charged under adult supervision. Please respect the correct polarity (-) or (+). Do not try to recharge 

non-rechargeable batteries. Do not throw batteries into the fire. Replace all batteries of the same type/brand at the same time. The supply 

terminals are not to be short-circuited. Remove exhausted batteries from the toy. Batteries should be replaced by adults. Remove batteries 

if the toy is not going to be played with for some time. Removable batteries are to be removed from the toy before they are charged. The 

packaging should be kept since it contains important information.

The DUCK HUNTER - LAUNCH & LOAD is a revolutionary new toy that allows anyone to have 

the virtual learning experience of hunting a Duck in complete safety.

The Infrared Blaster is equipped with a launch mechanism that is used to charge and launch a 

fully functional flying “Ornithopter” Duck into the air.  An Ornithopter is a device that flies by 

flapping its wings.  Thus, the Ornithopter Duck’s flying pattern is very life-like.   The Infrared 

Blaster then uses a safe narrow infrared beam to shoot down the Duck.  The Duck will fly for up 

to 30-40 seconds from a 15 second charge. The body of the Duck is made of an ultra-light and 

flexible foam which provides excellent structure and resistance to damage. Since the flying 

direction of the Duck can be preset, it is possible to play with the DUCK HUNTER - LAUNCH & 

LOAD toy indoors or outdoors. It takes 3 direct hits from the Infrared Blaster to bring down the 

Duck.  It is possible to have a competitive game-play with any number of multiple players or to 

practice solo target shooting accuracy.  A multiple player game-play consists of counting the 

number of shots fired to bring down the Duck.  The person who fires the least amount of shots 

is the winner.

INSTRUCTION MANUAL

Do not modify your DUCK HUNTER - LAUNCH & LOAD toy. Do not use in strong winds, 

use only in VERY mild conditions! Do not use in rain, snow or around heavy debris! Do not 

use near electrical lines! Do not use around smoke or flames! Do not use around water! 

Do  not  use  around  electricity!  Do  not  use  in  crowded  areas!  Do  not  use  around  air 

conditioning!  Do  not  use  around  air  vents!  Do  not  use  around  ceiling  fans!  Do  not  use 

around large obstacles! Do not use in very small spaces! Do be conscious of changes in 

your area! Any changes or modifications to this product are strictly prohibited and will void 

product  warranty.  Keep  moving  wings  away  from  eyes,  hands,  hair  and  loose  clothing. 

Always  turn  off  your  Infrared  Blaster  when  not  in  use.  Always  remove  batteries  from 

Infrared  Blaster  during  storage.  Always  replace  Infrared  Blaster  with  NEW  alkaline 

batteries for optimal performance. Keep your instruction manual in a safe place for future 

use. Only use the provided Infrared Blaster included with the DUCK HUNTER - LAUNCH 

& LOAD to charge the capacitor installed in the DUCK HUNTER - LAUNCH & LOAD.

You can replace the original wings on your Duck if they become damaged. A new set of 

wings can be purchased by contacting Interactive Toy Concepts as outlined in this manual.  

To replace the wings, do the following:

1.  Make sure the Duck is not flapping its wings.  In other words, shoot it down with the 

Infrared Blaster or allow it to expire the charge in its capacitor and finish flapping its wings.

2.  Gently disconnect the rear corner of the wing that is tethered to the body by a ball joint.

3.  The leading (front) edge of the wing is a thin carbon fiber rod. Gently pull this rod out of 

the gear box mechanism housing at the front.

4.    Installation  of  the  new  wing  is  the  reverse  of  the  wing  removal  procedure  with  the 

following minor difference.  The carbon fiber rod has a slight notch cut into its end so that it 

will  only  fit  properly  into  gear  box  mechanism  housing  one  way.  Use  caution  when 

inserting the carbon fiber rod.  If it is not going in smoothly, it is misaligned.

1.  Turn on the Infrared Blaster!  The switch is located on the bottom of the Infrared Blaster just ahead of the 

trigger.

2.  Slide the Reload Pump all the way back and release it to arm the Duck Launching Mechanism.

3.  Prepare your Duck for launching by mounting it on the blaster and sliding it into its groove.

4.  Press and hold the trigger for 15 seconds to charge the Duck.

5.  Aim the Infrared Blaster in the direction you would like the Duck to fly.  It is best to aim the infrared blaster 

upwards. Press the Launch Button on the left side of the Infrared Blaster to launch the Duck.  The Duck will 

start flapping its wings and fly away.

6.  Start hunting the Duck by shooting a safe infrared beam at it every time you press the Infrared Blaster’s 

Trigger.  You will need to reload the Infrared Blaster by sliding back and forth the Reload Pump after each shot.  

It takes 3 direct hits to bring the Duck down.