Lincoln Electric IM530-C Benutzerhandbuch
–
20
–
MAINTENANCE
WELDANPOWER 125
To service the pre-cleaner:
Remove the wing nuts and cover for Codes 10158,
10160)
10160)
Remove the cover for (Codes 11183, 11406).
Carefully remove the foam pre-cleaner from the filter
element.
Carefully remove the foam pre-cleaner from the filter
element.
1. Wash in liquid detergent and water.
2. Squeeze dry in a clean cloth.
3. Saturate in clean engine oil.
4. Squeeze in a clean, absorbent cloth to remove all
excess oil.
Carefully place the pre-cleaner back over the filter
element and reinstall the air cleaner cover and wing
nuts.
element and reinstall the air cleaner cover and wing
nuts.
CLEAN ENGINE: Remove dirt and debris with a cloth
or a brush. Do not clean with a forceful spray of
water. Water might contaminate the fuel system. Use
low pressure air to blow out the machine periodically.
In particularly dirty locations this may be required
once a week.
or a brush. Do not clean with a forceful spray of
water. Water might contaminate the fuel system. Use
low pressure air to blow out the machine periodically.
In particularly dirty locations this may be required
once a week.
Engine Adjustments
OVERSPEED IS HAZARDOUS - The maximum
allowable high idle speed for this machine is 3750
RPM, no load. Do NOT tamper with the governor
components or setting or make any other
adjustments to increase the maximum speed. Severe
personal injury and damage to the machine can
result if operated at speeds above maximum.
allowable high idle speed for this machine is 3750
RPM, no load. Do NOT tamper with the governor
components or setting or make any other
adjustments to increase the maximum speed. Severe
personal injury and damage to the machine can
result if operated at speeds above maximum.
------------------------------------------------------------------------
Adjustments to the engine are to be made only by a
Lincoln Service Center or an authorize Field Service
Shop.
Lincoln Service Center or an authorize Field Service
Shop.
Slip Rings
A slight amount of darkening and wear of the slip rings
and brushes is normal. Brushes should be inspected
and brushes is normal. Brushes should be inspected
when a general overhaul is necessary. If brushes are
to be replace, clean slip rings with a fine emery paper.
Do not attempt to polish slip rings while engine is
running.
to be replace, clean slip rings with a fine emery paper.
Do not attempt to polish slip rings while engine is
running.
------------------------------------------------------------------------
Hardware
Both English and Metric fasteners are used in this
welder.
welder.
(For Codes 11183, 11406)
Robin / Subaru
Air Filter Element
279-32616-00
Air Filter Pre-Cleaner
279-32611-00
Spark Plug
NGK BR6 HS
(Resistor Type)
(Gap .030” [.76mm])
WARNING
CAUTION
Engine Maintenance Parts
(For Codes 10158, 10160)
B & S Vanguard® 9 HP
Air Filter Element
B & S 710266
Air Filter Pre-Cleaner
B & S 710268
Spark Plugs
B & S 491055
(Resistor Type)
Champion RC12YC
Autolite 3924
(Gap .030” [.76mm])