Sterling 882.01749.00 Benutzerhandbuch

882.01749.00  

34 

of 

93 

 

 

The control system is factory-programmed. However, specific values need to be verified prior to 

operation (basic parameter settings). The input values will be saved and still be available if the feeder 

is switched off, or a power failure occurs. Please refer to Appendix B for these values.  

Extrusion operations require a “span factor” to be entered into the basic settings. These are also 

explained in Appendix B. 

 
Prior to putting your new Digital Dosing feeder on-line: 

   

   

Configure the feeder control for motor speed, encoder pulses, sensors, and alarm 

options.  

 

   

   

Tune the drive. 

 

  

   

Enter a recipe. 

 

   

   

Calibrate the additive weight for best accuracy. 

 

          NOTE:     Recipe parameters are different for Injection Molding, Extrusion – 

     

                  Constant, and Extrusion - Proportional operation.  See each individual section for  

                           details.   

                       

                           Once the feeder is on-line, recipes can be saved for later recall (up to 50 standard).