Toshiba EO1-33056D Benutzerhandbuch

Seite von 139
7. SUPPLY SPECIFICATIONS 
ENGLISH VERSION EO1-33056 
7.1 Media
 
E7- 3 
7.1.3  Detection Area of the Reflective Sensor 
The detection range of the Reflective Sensor of the movable sensor is 70 mm from the media edge.   
The Reflective Sensor of the fixed sensor is positioned at the centre of media. 
The reflection factor of the Black Mark must be 10% or lower with a waveform length of 950 nm. 
The Reflective Sensor should be aligned with the centre of the Black Mark.   
 
 
 
 
 
 
 
7.1.4  Effective Print Area 
The figure below illustrates the relation between the head effective print width and media width. 
 
 
 
 
 
 
 
 
The figure below shows the effective print area on the media.  
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Sensor should be positioned at 
the centre of the black mark. 
Centre of media 
Min. 12 mm
Media feed direction 
Min. 2.5 mm
2.2 
mm
 
175.0 mm (Max. media width) 
170.6mm + 0.2mm 
(Head Effective Print Range) 
Out of print range
Out of print range 
2.2
mm
NOTES: 
1.  Be sure not to print on the shaded area in the above figure.  Printing this area may cause ribbon wrinkles, 
resulting in a poor print quality of the guaranteed print area. 
2.  The centre of media is positioned at the centre of the Print Head. 
3.  Print quality in the 3-mm area from the print head stop position (including 1-mm non-printable area for print 
speed slow down) is not guaranteed. 
 
Detecting the black 
marks on the back. 
Start line
Area to be detected.
Area to be detected. 
Media feed direction 
1.5 mm from the
left edge of media
Media width  
(backing paper width is not included.)
Media height 
10 –1707 mm 
1.5 mm from the 
right edge of media 
1mm
1mm
Guaranteed print area
70mm 
Movable Sensor 
Fixed Sensor