HP (Hewlett-Packard) CF081A#BGJ Benutzerhandbuch
Interconnect board (ICB)
Before proceeding, remove the following components:
●
.
●
Formatter. See
●
Right rear cover. See
.
●
Left cover. See
●
Rear cover and upper rear cover. See
NOTE:
It is not necessary to separate the upper rear cover from the rear cover to remove the
interconnect board (ICB).
Remove the ICB
WARNING!
Do not remove the ICB from a product and then install it into a different product.
Failure to follow this warning will result in severe damage to that product and cause it to be unusable.
HP recommends that if you remove and replace the ICB, you should destroy the discarded ICB so that it
can not accidentally be installed in a different product.
CAUTION:
ESD sensitive part.
1.
Disconnect one connector (callout 1; J105) from the DC controller, and then remove one screw
(callout 2).
NOTE:
Figure 2-125
Remove the ICB (1 of 3)
2
1
158
Chapter 2 Removal and replacement
ENWW