HP (Hewlett-Packard) CF081A#BGJ Benutzerhandbuch
7.
Rotate the corner of the assembly away from the product until you can see the PCA, and then
remove the assembly from the product.
Reinstallation tip
When the laser/scanner is properly positioned in the chassis, the plastic
parts which protrude at the front and rear of the product will be firmly seated against the locator
tabs on the chassis. Verify that the assembly is correctly seated, and then install the spring.
Figure 2-184
Remove the laser/scanner assembly (C/Bk) (7 of 7)
1
2
Reinstall the protective glass cleaner (PGC) actuators
1.
The following figure shows a dislodged PGC actuator.
TIP:
If the actuator and spring are only slightly dislodged, you might be able to easily push them
back into place.
Figure 2-185
Reinstall the PGC actuators (1 of 5)
198
Chapter 2 Removal and replacement
ENWW