HP (Hewlett-Packard) CF081A#BGJ Benutzerhandbuch
Component tests
Component test (special-mode test)
This test activates individual parts independently to isolate problems.
Each component test can be performed once or repeatedly. If you turn on the Repeat option from the
drop-down menu, the test cycles the component on and off. This process continues for two minutes, and
then the test terminates.
NOTE:
The front or side door interlocks must be defeated to run the component tests. Some tests may
require that the ITB and print cartridges be removed. The control panel display prompts you to remove
some or all cartridges during certain tests.
1.
Press the Home button.
2.
Open the following menus:
●
Administration
●
Troubleshooting
●
Diagnostic Tests
3.
Press the Down arrow button to highlight the Component Test item, and then press the
OK
button.
4.
Select the component test options for the test you want to run.
Table 3-9
Component test details
Component test
Motor or solenoid number
Comments
Transfer Motors
M5
All motors related to cartridges and belts
Belt Only
M10
Remove all print cartridges to perform
this test. Rotates the ITB belt. You can
hear the auger motor running.
this test. Rotates the ITB belt. You can
hear the auger motor running.
Cartridge Motors
●
M3: yellow
●
M4: magenta and cyan
●
M5: black
Activates three drum motors at a
specified speed for 10 seconds.
specified speed for 10 seconds.
Black Laser Scanner
M8
Activates the black/cyan scanner motor
for 10 seconds.
for 10 seconds.
Cyan Laser Scanner
M8
Activates the black/cyan scanner motor
for 10 seconds.
for 10 seconds.
Magenta Laser Scanner
M9
Activates the yellow/magenta scanner
motor for 10 seconds.
motor for 10 seconds.
Yellow Laser Scanner
M9
Activates the yellow/magenta scanner
motor for 10 seconds.
motor for 10 seconds.
280
Chapter 3 Solve problems
ENWW