Mentor v8.6_4 Benutzerhandbuch

FastScan and FlexTest Reference Manual, V8.6_4

Tools Supported: FlexTest

Scope: Setup mode

Prerequisites: You must add strobe times with the Add Pin Strobes command

before you can delete them.

DELete PIn Strobes primary_output_pin... | -All

Removes the strobe time from the specified primary output pins.

The Delete Pin Strobes command deletes the strobe time added to the primary
outputs using the Add Pin Strobes command. You can delete the strobe time of
specific pins or of all pins.

Once you delete a primary output pin’s strobe time, the pin uses the default strobe
time. For nonscan circuits, the default strobe time is the last timeframe of each test
cycle. For scan circuits, FlexTest designates time 1 of each test cycle as the
default strobe time for every primary output. You can change the default strobe
time by using the Setup Pin Strobes command.

•

A repeatable string that specifies a list of primary output pins whose strobe
times you want to delete.

•

A switch that deletes the strobe times of all primary outputs; the pins then use
the default strobe time.