Muratec F-112 Benutzerhandbuch
M
AINTENANCE
5.9
5
Replacing the ADF Rubber Pad
You can purchase a ADF rubber assembly from a Muratec dealer.
1
Open the control panel by gripping its bottom and pulling it upward.
2
Disconnect the support on the left side of the machine from the control
panel and lift the control panel up to the complete open position
panel and lift the control panel up to the complete open position
3
Remove the control panel from the machine by disconnecting the hinge
on the right.
on the right.
N
OTE
: Be careful no to disconnect the connector on the control panel from the
machine as it turns the LCD off.
4
Using a screw driver, press the slots on the ADF rubber plate to unlatch
the plate and the ADF rubber.
the plate and the ADF rubber.
5
Align the holes on the new ADF rubber and the plate and inset the tabs
on the plate into the slots on the machine. Press them until they are
latched.
on the plate into the slots on the machine. Press them until they are
latched.
6
Replace the control panel by connecting the hinge on the right first
then inserting the left arm while pushing the control panel to the right.
then inserting the left arm while pushing the control panel to the right.
7
Reconnect the support and the control panel, then close the control
panel firmly until it clicks into place.
panel firmly until it clicks into place.