Xerox 5230A Benutzerhandbuch

15 Problem Solving 

372

This section explains the restrictions that apply while using SMB.

• The IP address is a unique address administered system-wide. Consult with the 

system administrator when setting the necessary parameters.

• The subnet mask and gateway settings may also be required, depending on the 

networking environment. Consult with the system administrator when setting the 
necessary parameters.

• When a port is enabled and there is insufficient memory, the port may be disabled 

automatically. In this case, disable all unused ports and reallocate the memory.

• The [Receiving Buffer - SMB] memory allocation needs to be set in response to the 

operating environment. If the memory allocation is too small, it may prevent 
receiving messages.

• The IP address is a unique address administered system-wide. Consult with the 

system administrator when setting the necessary parameters.

When the machine is switched off
The following actions take place when the machine is switched off.

• When [Receiving Buffer - SMB] is set to [Spool to Memory]:

All print data spooled in machine memory, including the data currently being printed, 
is deleted. There is no print data on the machine when the machine is switched on.
However, if the machine is switched off immediately after a print request, the print 
data may be stored on the client. In this case, the print request can be reissued when 
the machine is switched on, and the print data is printed on the machine.

• When [Receiving Buffer - SMB] is set to [Spool to Hard Disk]:

All print data spooled on the machine hard disk, including the data currently being 
printed, is retained. A print request can be reissued when the machine is switched 
on, and the print data is printed on the machine.

The document owner is 
invalid.

Check whether the owner of 
the selected document 
matches the Windows log-in 
name.

Use the owner name of the 
document to log in to 
Windows, and then delete the 
document.

Service Pack 4.0 or later is 
not installed in the system. 
(In Windows NT 4.0)

Check the Service Pack 
version displayed when you 
start Windows NT 4.0.

Install Service Pack 4.0 or 
later.

Job history displays a 
message that the document 
name is undefined instead of 
the correct job name.

Change the [Receiving Buffer - SMB Spool] setting from 
[Memory] to [Hard Disk].